Garage Floor Epoxy FAQ

Typical installed prices run about $3–$6 per sq ft for solid-color epoxy, $4.50–$8 for flake epoxy, $5.50–$10 for polyaspartic flake and $7–$12 for metallic. A typical 2-car garage usually lands around $2,000–$4,000. Use the cost calculator for a ballpark.

At typical Treasure Valley prices, 400 sq ft runs about $1,200–$2,400 for solid-color epoxy, $1,800–$3,200 for flake epoxy and $2,200–$4,000 for polyaspartic flake, before heavy repairs. Small floors may also hit an installer's minimum job price.

Low quotes often skip diamond grinding, use thin water-based products, or leave out repairs and topcoats. Those floors look fine at first but tend to peel under hot tires. Compare what's included — grinding, repairs, flake coverage and topcoat — not just the total.

No. Estimates are free and done on site so we can measure, check the concrete and moisture, and show you color samples before giving a written quote.

Plain epoxy can amber in direct sunlight, is slick when wet without texture, and can soften under very hot tires if it's thin or poorly bonded. A flake broadcast adds grip, and a polyaspartic topcoat adds UV and heat resistance. Good prep prevents most failures.

Polyaspartic cures faster, stays UV-stable and handles heat better; epoxy builds thicker and costs less. Many floors use an epoxy base with a polyaspartic topcoat. Read epoxy vs polyaspartic for the full comparison.

A colored base coat with vinyl chips broadcast across it until fully covered, then scraped and sealed with a clear topcoat. It looks like granite or terrazzo, hides dust and tire marks and adds grip. See flake epoxy floors.

Smooth, high-gloss floors can be slick when wet. Flake floors have light texture, and an anti-slip additive can be mixed into the topcoat. We recommend it for garages where snowmelt drips off vehicles in winter.

Epoxy can amber over time in strong UV light, which matters near an open garage door in Boise's high-desert sun. A UV-stable polyaspartic or polyurethane topcoat helps the floor keep its color.

Most 2-car garages take one to two days. Foot traffic is typically fine after about a day, and vehicles usually wait a few days depending on the system and temperature.

Yes — the floor needs to be clear for grinding and coating. Most people move items to the driveway or a covered area for the install. Ask at the estimate if you need help planning around large items.

We grind with diamond tooling connected to dust-extraction vacuums, which captures most of the dust. Garage doors stay mostly closed during grinding to keep dust out of the house.

Yes, with the right products and conditions. Epoxy cures slowly in a cold garage, so we may heat the space or choose a polyaspartic system that cures at lower temperatures. We'll recommend the best timing for your floor.

Yes, after the slab has cured — generally about 28 days. Builder curing compounds must be ground off. See coating a new-construction garage floor.

A professionally ground and installed residential floor commonly lasts many years, with the topcoat taking the wear. Thin kits on unground concrete often fail much sooner. More in how long garage epoxy lasts.

A well-installed flake floor usually still looks good after five years, with some light scuffs and dulling in the tire paths. Sun-exposed plain epoxy may amber. A cleaning and fresh topcoat can bring back the gloss.

Sweep or dust-mop regularly and mop with warm water and a mild, non-acidic cleaner. Squeegee out winter slush so deicers don't sit on the floor, and wipe oil or fluid spills promptly.

A sealed coating protects the concrete from deicers far better than bare concrete. Rinse or squeegee heavy slush periodically. Read garage floors and Idaho winters.

Hot tires can soften weak coatings and pull them off the floor, especially after summer drives. Proper grinding and a hard topcoat prevent it. Details in hot-tire pickup and UV yellowing.

Throughout the Treasure Valley, including Boise, Meridian, Nampa, Caldwell, Eagle, Kuna, Star, Garden City, Middleton, Emmett and Mountain Home. See all service areas.

Yes. We coat detached shops, RV bays and pole barns (see shop & RV floors) and basement floors after moisture testing (see basement floor epoxy).